From:Dave Hennessey e-mail:dave@toyhouse.org
Subject:RE: Generator drive belts Date:Fri Jun 26 19:05:09 2015
Response to:5803
Michael,

That multi-link belt is way cool.

I find it easier to unhook the magento than the coupling, but those bolts are a real pain to get back in. But I went the old school way on my KJ, and after a couple of trial and errors, settled on a Napa 3L 180W belt. So far so good.

Dave



----- ORIGINAL MESSAGE FOLLOWS -----
I obtained a foot of a multi link 3/8" drive belt from
Sulphur Grove Tool: www.sgtool.com sales@sgtool.com 800.657.5064 that fit the generator drive sheaves on my '23. Remove links until the tension is right, and the absolute best thing is that you do not have to unbolt the drive coupling. The fixed length 3/8" belts available were either too long or too short and for under twenty bucks I solved the problem. Hopes this works out for someone as well as it did for me. MF