From:	Mark Hill	e-mail:	hillm@canton.edu
Subject:	Cutting Cutter 5	Date:	Wed Mar 2 18:54:40 2011

Caps,bearings,ARP studs and nuts all aline bored parallel to the deck and the pan rail surface. All this should have been good from Henderson right? Think again not even close. Dont you just use the old bearings and take out some shim ? Maybe if the crank is tight leave a nut loose that will work. Be sure to use aircraft safty wire that will impress the hell out of everyone. I guess all thats left to do now is groove and blend the the shims